Sterling 442124-0 Installation Guide download pdf (Page 6)

Install the Lavatory (cont.)

NOTE: You can also use other fastening devices of sufficient size

and strength.

Install the hanger bolts to the backing material. Thread the cap

nuts onto the two hanger bolts. Use a 9/16″ wrench to thread the

hanger bolts into the wall so 1″ (2.5 cm) of each bolt remains

exposed between the cap nuts and ﬁnished wall.

Remove the cap nuts.

Install the faucet and drain to the lavatory according to the

manufacturer’s instructions.

Move the pedestal and lavatory back into position and ﬁt the

lavatory over the hanger bolts. Make sure the lavatory rests

directly on the pedestal and ﬁts ﬂat against the wall.

Remove the lavatory and set it aside.

CAUTION: Risk of product damage. Do not overtighten or

damage may occur.

Thread a washer and lag bolt through the pedestal hole and into

the ﬂoor until the washer contacts the pedestal. Tighten the lag

bolt until snug.

Move the lavatory back into position over the hanger bolts.

Double check the installation to be sure it is level and properly

positioned.

Install washers and cap nuts to the hanger bolts and tighten until

the washers contact the lavatory. Tighten the cap nuts until snug.

Connect and tighten the trap to the drain.

Complete the water supply connections to the faucet according to

the instructions packed with the faucet.

Clean up with a nonabrasive cleaner.

Care and Cleaning

For best results, keep the following in mind when caring for your

Sterling product:

•

Use a mild detergent such as liquid dishwashing soap and warm

water for cleaning. Do not use abrasive cleaners that may scratch

or dull the surface.

•

Carefully read the cleaner product label to ensure the cleaner is

safe for use on the material.

1019859-2-B 6 Sterling

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Sterling 442124-0 Installation Guide Page 6