Sterling 77301100-0 Installation Guide download pdf (Page 4)

Operating Your Bath

Close the drain, then ﬁll the bath to the desired water level.

Use your hand to test the water temperature for comfort and safety, then carefully enter the bath

basin.

Press the air switch to activate the airjets.

Press the air switch multiple times to cycle through the various airﬂow speeds or deactivate the

airjets.

Carefully exit the bath, then open the drain to release the water from the bath.

NOTE: If the bath with airjets does not function properly, please refer to the ″Troubleshooting″ section.

Care and Cleaning

Cleaning Your Airbath

For best results, keep the following in mind when caring for your STERLING product:

Always test your cleaning solution on an inconspicuous area before applying to the entire surface.

Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and

dry overspray that lands on nearby surfaces.

Do not allow cleaners to sit or soak.

Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring

pad to clean surfaces.

For detailed cleaning information and products to consider, visit www.sterlingplumbing.com/support.html.

To order Care & Cleaning information, call 1-800-456-4537.

Flushing Your Airbath System

Flush your airbath system twice a month or more, depending upon usage.

Fill the airbath with warm water to a level 2″ (51 mm) above the highest jet, or leave water in the

airbath after using.

Add 2 teaspoons (10 ml) of a low-foaming, powder automatic dishwasher detergent and 20 oz. (591

ml) of household bleach (5% - 6% sodium hypochlorite) to the water.

Run the airbath for 5 to 10 minutes then shut off the airbath and drain the water.

Air Switch

1139487-5-F 4 Sterling

1 2 3 4 5 6 7 8 9 ... 23 24

No comments

Sterling 77301100-0 Installation Guide Page 4